MKUK4 Keypad Info

by Affinity Agency
MKUK4 Keypad

Here is a quick and easy build guide for the MKUK4 Keypad.

  1. Break apart the PCB. DO NOT CHANGE THEIR ORIENTATION. The only work one way. 
  2. Solder the diodes D1, D2, D3, D4. Make sure the line on the diodes is aligned with the lines on the pcb.
  3. Snip the excess from the diodes. Use some of the excess wire to solder through R1.
  4. Solder the headers on the Pro Micro slot. make sure that the black part of the header is on the side of the PCB that says RAW.
  5. Push the switches into the switch plate, and solder the switches, they only go one way!
  6. If you want LEDs, solder them through the switches. Remember the short leg goes in the square pad. Snip the excess.
  7. Solder the Pro Micro. Make sure the raw pin lines up with the RAW marking. Snip the excess of the headers.
  8. Screw in the spaces and the back cover.
  9. Plug in the USB. Open QMK toolbox and flash using this hex. – Download

To customise the keymap go to config.qmk.fm and select handwired/mechboards_micropad as the keyboard.